Bora Care With Mold Care Mixing Instructions

Of sheathing, insulation, or drywall. 5:1 solutions will remain stable for up to 30 days.

Pin on misc

To aid in the mixing process use warm or hot water if available.

Bora care with mold care mixing instructions. Kills and prevents mold in homes, kitchens, bathrooms, crawlspaces on wood surfaces such as bare wood, plywood, particleboard, and osb. Continue to mix until solution is fully mixed. 5:1 solutions will remain stable for up to 30 days.

Do not leave unused solution under pressure or in tank overnight. Clean and/or flush equipment and lines with water after use. Give us a call if you need more help.

The solution to a spray tank. Allow to mix until uniform. Continue to mix until solution is fully mixed.

5:1 solutions will remain stable for up to 30 days. Follow the instructions below for proper mixing. *mix entire contents with 5 gallons of warm water (see mixing instructions above).

Do not leave unused solution under pressure or in tank overnight. Normal mixing time may be 5 minutes. But using a 3:1 or 5:1 would only be effective on fungus.

No label dosage rates should be exceeded. Mix in a clean container and stir the solution until completely uniform. Bora care mixing or dilution is directed in the product label.

Mix 1 pint of mold care with 1. For fungus, its 1:1, 3:1 or 5:1. Follow manufacturer's instructions and read the entire conditions, disclaimer and directions for use.

This product cannot be mixed with any product containing a label prohibition against such mixing. As a concentrate, boracare dilutes with water before use. When applied, it diffuses into the wood and remains there for the life of the wood.

Do not leave unused solution under pressure or in tank overnight. In summary, the rates are pretty equal so our best advice is that if you were concerned about both, use either a 1:1 or 2:1 mixture and you’ll get control of both. Do not leave unused solution under pressure or in tank overnight.

5:1 solutions will remain stable for up to 30 days. Clean and/or flush equipment and lines with water after use. Clean and/or flush equipment and lines with water after use.

Hydrogen peroxide is a good alternative to chlorine bleach because it is safe to use and doesn't damage the environment, nor does it leave behind toxic residue or produce toxic fumes like chlorine bleach does. Termites cannot consume, live in or tube over treated wood. *one gallon of finished solution treats 400 board feet of wood or 400 sq.

To aid in the mixing process use warm or hot water, if available. As a concentrate, boracare dilutes with water before use.

It doesn't have quite as good properties as AM 128 shown